Find all the documentation for downloading your vintage hifi or audiophile Kenwood on vintageshifi.com, whether it is to use your device or to repair it. You will find these documents in the form of PDF files: Download service manual, audio manuals, hifi manuals, service information, schematics, owner's manuals, brochures, catalogs for amplifiers, pre-amps, power amps, tuners, tape decks, cd players etc. The service is intended for individuals and professionals, a site accessible with and without proxy, it is completely free, without limitation and without registration. If a file does not open, it is likely that the download is incomplete so be sure to download the files one at a time, and at a time of low traffic.

Hi Daryl, There are two options in which you can connect your EQ to the AMP. The preferred way is through the TAPE MONITOR jacks.

High-Power Audio Amplifier Construction Manual $37.76 Kenwood stereo integrated amplifier model ka-5700 parts or repair $26.00 Tbf60/5r, tbf60/5i, tbf120/7r,tbf120/7i trm60/5i csm mts servo amplifier repair $365.00. Kenwood amplifier 5i excelnt kenwood stereo integrated amplifier a-5j (110) made in japan (genuine) 100% working good.

The signal level at this stage is well suited for the EQ to handle. But if you are using the TAPE monitor jacks, then go for option 2. Take out the jumper connectors and plug the RCA cords from your EQ. The voltage level at this stage is around 1-2 volts AC. Most EQs can handle lower than 1.5volts, higher than that will cause a slight distortion.

In some high end EQ models there is a voltage level selector, that you can toggle between high and low level input signals. Anyway don't worry much on this voltage levels, the 2 volts is unusual unless you have the volume control at maximum. Alternate between the two options so you can decide on which you prefer. Enjoy listening!